Door Hanging Instructions with Photos

i have hide a door installed one of them needs to be fixed the top roller is coming loose the screws are pulling out i didnot install the doors i have no idea on how to fix without taking the trim off help

Twice with two different contractors I have had to request a correction to exterior door installations. In both cases, the builder failed to install the door flush with the inward swing side of the door. In addition to just looking wrong, the door hits the jamb when opening preventing the door from swinging 180 degrees flush with the wall.

Both builders corrected the situation, but insisted the original installation was the way they always do it. Since these were both on walls thicker than standard 2" X 4" construction. I just assume they failed to order the right door for the thicker wall.

Is there ever a reason to install a door not flush with the wall?

I RECENTLY PURCHASED HOLLOW INTERIOR DOORS WHICH NEED TO BE TRIMMED BY 1 1/2" TO FIT THE FRAMEWORK. I AM AWARE THAT THERE IS VERY LITTLE TO PLAY WITH TO REDUCE THE WIDTH OF THE DOOR, COULD YOU ADVISE HOW TO REMEDY THE PROBLEM.

Hello,
I am thinking of setting up to pre hang new doors and frames for a small hotel. How do I pre hang the doors to the frame to be installed after cutting out the old ones. Is there a jig set up for the hinges and the locks? I await your reply.
Thanks,
Mike

recently installed ext dbl door to shed r.o. Having problem with leveling bore with adjacent door side hole. How do I remedy this problem?

Have had external dutch doors replaced going to the back deck.
The old door was opened to various openings and remained in the desired opening w/o moving...........
the new door will not stay in the desired open position..........it swings such that the door is fully opened.
The installer swears the door is hung properly.......what is the issue?