Hello Mr. Carter,
I consider myself very handy around the house with everything from electrical to plumbing. However I feel like this problem is getting the best of me. The problem is we often (not everyday) have a very strong sewer odor that comes from the sink drain in our Master bath. It only occurs during the first use in the morning and seems to be emanating from the overflow hole entrance of the sink.
I have cleaned the drains (P-Traps) and do find residue from toothpaste and stuff but nothing that explains this. We do ever so often get the same smell from our walk-in shower too! I have heard that if the problem is a clogged vent pipe on the roof it will make a gargling sound and also it would smell other than first time we use the sink of a morning. We never hear these gurgling sounds. If you have any suggestions I would appreciate it. We have black plastic pipes and the house is 4 years old, this started about 1 year ago.
Thanks,
Jim
- - -
Jim,
I know exactly what the problem is. The odor is caused by bacteria that is breeding and multiplying in the bio-film that is coating the vertical drain pipe / tailpiece between the fixture trap and the actual drain outlet in the fixture. It is not the vent pipe unless you know for a fact the trap are being siphoned. The gurgling / suction noise is unmistakeable and you have indicated you never hear it.
The reason you smell this when you first use a fixture is simple. The motion of the water first hitting the bio-film releases some of the bacteria molecules into the air.
Remove the drain strainer in the shower and I guarantee you will see a layer of slimy goo on the side of the pipe leading down tot he trap. Clean off this goo. Do the same in the sink. You will have to remove the sink stopper to gain access to the vertical tailpiece.
The overflow tube that leads from the top of the sink to the tailpiece can also be a contributor to the problem. It is tougher to clean. I have had success using a turkey baster filled with a solution of Oxygen Bleach to kill the bacteria. You have to squirt the solution into the overflow tube vigorously several times and let it sit to try to coat the entire lining of the tube.
Tim
W3ATB
www.askthebuilder.com