Cutting Crown Molding Video

How can you make crown molding on a table saw?

I sure could use your HELP on this crown moulding project.

Usually I can figure out regular crown moulding, like on the ceiling, once I get into that cutting upside down and after a few mistakes it's ok...but this is really tricky.

Over my porch, I changed it from a curved piece of wood to and angle. So now I have this little horizontal corner, but also an angle, I think the center angle is 25 degrees. It's this crazy outside corner that is giving my the grief. Needless to say I have messed up a bunch of good wood whiuch I will use as expensive kindling ont eh firepit.

I looked in one book, something about horizontal and vertical angles.
This would be like doing crown moulding on a cathedral ceiling I guess. I would love it if you could help. I am way in over my head!

Thanks for any tips! Appreciate your site!

How do you cut wide crown(71/4")using sliding compound saw with 31.6 & 33.9 degree angles on saw? I know it can be done. I haven't figured it out yet. Frustrated!!!

8" crown to make 2 22 1/2 degrees to equal 45 degrees need bevel angle and mitre angle on saw laying it flat on saw