Tactica M250
Tactica M250 | Here's the Tactica M250 after it's taken out of the holster that can fit on your belt.
Tactica M250 - I Hate to Say It #FAIL
This could be my shortest tool review ever. I got the magazine out of the holster and BOOM - #FAILURE.
The slots the bits fit into were so tight, it was impossible for me to get the bits out of the magazine.
Not only could I not fit my finger into the small gap, but when I forced it in there the tips of the sharp bits hurt my finger so much I couldn't even begin to push them out.
I was only able to get the bits out of the magazine using my fingernail clippers. There was so much tension that when the bit finally came out, it shot across the room ten feet away!
The photos should tell the tale. Note the tiny gap between the top of the bits and the magazine. No way I could get my finger in there.
Love tool reviews? Look at my Gerber Prybrid Utility knife review.
It seems to me kind of useless, thanks for your info I will definitely not buy.
Nice review - quick simple to the point! Well done
I have the same problem with a set of expensive drill bits. The case that holds the bits is so tight that you cut your fingers trying to get them out! Love the bits but the case ruins it.
Thanks for an entertaining (and spot on) review. Why they don't make the bit holer tilt is beyond me. Even the cheapest bit cases at the hardware store have that...
Ok. Why did you want us to read it even though we are not in the market?
Simple!!!! So you can see that I TRASH things that are not well made. Too many of my peers think every tool is the best thing since sliced bread!
Thanks I bought a big caddy full of bits use a needle nose to get them out they don’t fall out for sure
How do you see the responses?